EDGE CLAMPS

This fixture uses two opposing edge clamps to self-center a large diameter in a V block.

Low-profile edge clamps can be used to grip the side of a workpiece for machining clearance, or to clamp over the top edge.

Milling fixture for exhaust manifolds, with four edge clamps and two swiveling backstops.

Workpiece supported by three fixed rest buttons and three fluid-advanced work supports, clamped by two edge clamps against opposing backstops. All components are manifold mounted for easy chip removal.

Edge clamp used with a block-type work support, both components manifold mounted for easy chip removal.

Clamping on a thin flange with opposing clamps, just below the machining plane, while locating from the housing. Note: opposing clamps require a pilot-operated check valve.

en_1090