Tubo singolo
a fissaggio regolare e a impilamento
|
Tubi gemelli
a fissaggio regolare e a impilamento
|
|
|
CARATTERISTICHE: Tubing Clamps are used to fasten hydraulic tubing to a machining fixture. These clamps provide additional strength and rigidity, increasing the life of the installation. Tubing Clamps should be used to support long tubing runs (4 feet maximum spacing) and exposed tubing bends.
FASCETTE PER TUBO SINGOLO: Each Tubing Clamp for a single tube consists of three part numbers:| | CLR-3300-892-TA Two-piece clamp body | | | CLR-3300-600-TA Weld-on mounting plate | | | CLR-3300-225-TA Mounting screw |
For stack mounting, order the following three part numbers for each additional Tubing Clamp underneath the top one:| | CLR-3300-892-TA Two-piece clamp body | | | CLR-3300-604-TA Stack-mounting screw | | | CLR-3300-335-TA Stack-mounting clip |
FASCETTE PER TUBO GEMELLI: Twin-tube clamps are especially useful for double-acting systems. Each Tubing Clamp for twin tubes consists of four part numbers:| | CLR-3300-891-TA Two-piece clamp body | | | CLR-3300-607-TA Weld-on mounting plate | | | CLR-3300-609-TA Washer | | | CLR-3300-225-TA Mounting screw |
For stack mounting, order the following three part numbers for each additional Tubing Clamp underneath the top one:| | CLR-3300-891-TA Two-piece clamp body | | | CLR-3300-613-TA Stack-mounting screw | | | CLR-3300-615-TA Stack-mounting clip |
CONSIDERAZIONE DI DESIGN PRECAUZIONI DI SICUREZZA: Never use tubing lines to lift fixtures.
MATERIALE: Clamp body > Polypropylene. |
|
