Collier de Serrage Simple
Montage Régulier et de Empilage
|
Collier de Serrage Double
Montage Régulier et de Empilage
|
|
|
CARACTÉRISTIQUES: Tubing Clamps are used to fasten hydraulic tubing to a machining fixture. These clamps provide additional strength and rigidity, increasing the life of the installation. Tubing Clamps should be used to support long tubing runs (4 feet maximum spacing) and exposed tubing bends.
GRIFFE POUR SIMPLE TUBE: Each Tubing Clamp for a single tube consists of three part numbers:| | CLR-3300-892-TA Two-piece clamp body | | | CLR-3300-600-TA Weld-on mounting plate | | | CLR-3300-225-TA Mounting screw |
For stack mounting, order the following three part numbers for each additional Tubing Clamp underneath the top one:| | CLR-3300-892-TA Two-piece clamp body | | | CLR-3300-604-TA Stack-mounting screw | | | CLR-3300-335-TA Stack-mounting clip |
GRIFFE POUR DOUBLE TUBES: Twin-tube clamps are especially useful for double-acting systems. Each Tubing Clamp for twin tubes consists of four part numbers:| | CLR-3300-891-TA Two-piece clamp body | | | CLR-3300-607-TA Weld-on mounting plate | | | CLR-3300-609-TA Washer | | | CLR-3300-225-TA Mounting screw |
For stack mounting, order the following three part numbers for each additional Tubing Clamp underneath the top one:| | CLR-3300-891-TA Two-piece clamp body | | | CLR-3300-613-TA Stack-mounting screw | | | CLR-3300-615-TA Stack-mounting clip |
CONSIDÉRATIONS DE CONCEPTION ET PRÉCAUTIONS DE SÉCURITÉ: Never use tubing lines to lift fixtures.
MATÉRIAU: Clamp body > Polypropylene. |
|
